The Concorde is now ready to start receiving decals
I am starting with the tail logo, I want to do the original British airways flag, but have some concerns on how well the decals will work so if all goes wrong I can swap over to the later logo with minimal fuss. First to go on are colour patches for the rudder hinge housings.
this side especially I am concerned about the eventual alignment. the dirty mark is caused by sanding down a moulding flaw I hadn’t previously noticed. I am not concerned as it will be hidden by the main tail decal.
The main flag has gone on ok on this side, there was a patch of white showing around the hinge housing, but I have filled that in with an offcut.
and the alignment of the stripes on this side look fine to the naked eye
whilst the tail decals set (After a coat of micro sol to make them conform to the moulded detail) I have applied all the upper surface decals. mainly walkway lines, apologies for the blurry photo.